[kaibart]

They ended production the end of 2017 so I would check heater falling that will be pcb

[kaibart]

Only use them to price jobs now as they are always the most expensive on parts have been for a while now

[kaibart]

Good to here its sorted 🙂

[kaibart]

Just a thought is the belt tensioned right on the pulley as if its the wrong way on the pulley I’ve had this happen not on this model though

[kaibart]

Don’t know what model i was looking at put wrong model number in I think

[kaibart]

If its error 21 and the model number is correct it will be heater which has resettable thermostat that has now been modified by new heater as the stat temperature is to low, the 3100 number you have posted doesn’t match the model number kai

[kaibart]

Check insulation on heater otherwise it will be module

[kaibart]

The 1st thing to check would be connections on the door lock and the door lock itself

[kaibart]

If you still have no heater after changing stats and there isn’t a front stat it will be the timer faulty

[kaibart]

No there are none listed on the drawings

[kaibart]

More than likely relay on pcb

[kaibart]

Ok undo the screws on the back left hand side to start then its a case of removing the facia so all the knobs need to be pulled off,there should be 3 screws holding the facia they are where the top door closes when you remove facia there will be 2 screws top left hand side and then pull the flap down and there will be 1 screw there and the panel will come off

[kaibart]

More than likely this change 1 or 2

[kaibart]

Its a new part they released 3 weeks ago they are having so much trouble with theses dryers no connect doesn’t list it probably have to contact hoover directly

[kaibart]

Yes they do have problems with the carbon brushes on the motors on hoover washing machines even when fitting genuine parts, dave thats a bit expensive for genuine brushes dave I don’t pay anywhere near that

[Author]

Posts