[kaibart]

Sounds like heater to me

[kaibart]

Something pulling the dbus down anything with 3 wires going to the main pcb disconnect and see if it does the same.
I will post up the test sequence for the machine when I get in there’s machine are a right headache, most common faults are door lock heater and dryer pcb

[kaibart]

It will be the sump that’s leaked on the heat pump there is a sump seal kit that dave has posted but good luck fitting it as this is very easy to snap/break trying to fit s better option is to change the sump completely

[kaibart]

It’s the main power module fault a relay on it is faulty change loads of them

[kaibart]

I change as many door seal as I can without removing the appliance only tip I can give you is a little lubricant on seal to make it go on easily and the Samsung door inner band are a left hand tread if I remember rightly

[kaibart]

This is normal at the moment nothing surprises me can’t say any appliance is built any better now than another and they say its because of moisture and people not wiping them out after use

[kaibart]

Heat pump or power module will be faulty more likely heat pump

[kaibart]

Possibly a hole in the sump hose by what your explaining

[kaibart]

May well be wires bitten from what your saying to

[kaibart]

It will be the pulley tensioners then

[kaibart]

Of this is on and draw is empty o would check the pump at the rear of appliance easy to access could be full of fluff and saying water container is full when its not

[kaibart]

I’ve had this before it’s a board fault

[kaibart]

Sounds like a wash heater is breaking down under load

[kaibart]

Yes the way I get the 3 grey wires out is snap the plastic with a flat blade screwdriver as dave has said the motor connection is purple and black on the hige end dishwashers the harness is probably in stock direct and cheaper have a look

[kaibart]

The callout on the hoover heatpump dryer with hoover is £160 or over £300 to get a plan with d&g

[Author]

Posts