Forum Replies Created
-
Posts
-
Re: Washing Machine Height Help!
Removing the levelling feet is a no no too. Sounds like your floor to worktop ratio is pretty rubbish overall and something has to give. But these compromises are just too much and whatever machine you choose the guarantee will be nul and void from the outset I’m afraid. Is there nowhere else you can instal your washing machine?
Re: Bosch Classixx 1200 Express Drum not rotating
Check with a multimeter that you have continuity between the motor terminals (3 sets of 2). If so the motor should be OK and the problem therefore is the connecting lead to it I would imagine.
Giving us the full model number of your machine would help too. (inside the door).
Re: Bosch WAB28061GB/05 washer
Gary59 wrote:Wired on a new motor which took a while
I’m not altogether sure what you mean by that Gary but assuming the motor and brushes are OK then the symptoms suggest perhaps an earth leak on the heater?
Re: Fabric softener not dispensing
It’s very common for black mould to develop in the fabric conditioner water channel. And in order to clear this you’ll need to remove the lid and access the dispenser unit after removing both fill pipes attached to it.
Re: Bosch WAQ28461GB/12 Cleared Blockage Stuck 1 min See Pho
What you think is 1 minute shown in the window may well be in fact 1 hour delay start? And the key flashing is the child lock. So try holding the start button for 5 seconds in the hope that that will reset it?
Re: SMS40T32UK09 Service Manual Please
Ah I see 🙁
I’m not aware of any test cycle that can be carried out without connecting BSH’s own software programmer.
Re: Bosch vented dryer
Sensor drying does work OK using the normal heat programmes on most fabrics. Low heat should only be required for more delicate synthetics and in cases like this using a timed dry setting is by far the best or only solution.
The symptoms indicate to me that there is no real problem here and adopting the solution above should be the resolve.
Re: WJD 1667 Zanussi – worth changing bearings?
Major job for the expert anyway but do’able for the avid DIYer. Tub out to split and remove the inner drum then hammer out the bearings. You’ll need a new tub gasket as well as the bearing kit by the way, ohh and Band Aids for your bloodied wounds.
Or, bite the bullet and buy a new machine. It’s what the wife would want 😉
Re: Hoover SE147 auto washer
Are you in the Trade? Apply for trade membership (there’s a link to it somewhere around here- a mod might help you further 😉 )
Re: Washing Machine Suddenly Stop on Wash Cycle?
“Spins?” Do you just mean the drum turns? If so it might be that the heater is no longer working?
