Forum Replies Created
-
Posts
-
Re: Bosch WFX3267GB/10 – motor won’t turn
There’s no reset required on these appliances after btush/motor failure. If , after replacing the brushes the motor fails to start then either the motor is totally goosed or the motor has taken out the control module.
Re: Bosh WTW863s0gb/11 container full
Its a heat pump dryer so you don’t get the same intense heat that you get from conventional dryers . They are very energy efficient but do take a little longer on their cycles.
Re: Bosh WTW863s0gb/11 container full
‘Container full’ is normally a blocked pump or blocked hose between pump and container. A blocked condenser would normally be indicated as ‘clean filter.’ The drain pump is situated on the RHS by the compressor. Whilst not the easiest thing to access , it can be removed and cleaned ok. These are susceptible to blockages , especially if there are pets present.
Re: bosch wae24260gb/01 no heat
They normally won’t show a no-heat fault code to the customer , just take an extra approx 105 minutes to complete. I presume you’ve checked the heating element ?
Re: Bosch WAE24369/GB/13 – not starting
The reason its saying zero is probably because its still showing the end of the last cycle used . And Martin , because I’m a nice chap I would let them off as ‘customer advice’ …..allowed for appliances less than 6months old 🙂
Re: Siemens Combi M/wave HB86K581B cuts out after 3 seconds
Normally it’s an inverter failure but also check safety fuse and door switches operation.
Re: bosch sms63e12gb/01 dishwasher
To be honest , intermittent e:24 is such a pain in the backside. Whilst it can mainly point towards slow draining , it can be a blocked drain hose/sink connection, stuck non-return valve , drain pump access cover loose , faulty/blocked drain pump or failing/blocked heat pump . It can sometimes be difficult to diagnose especially when it doesn’t occur when you’re there. Sorry I can’t be more specific but the error code has too many possibilities to pinpoint it exactly without examining or testing the machine personally.
Re: Neff Oven – enr U1452N3GB/02
My guess would be that he’s fitted it from the front and hasn’t put ALL the cables back onto the element itself .
Re: Bosch SMV50EOOGB/21 stopping in cycle.
1st thing – check installation to make sure the decor door/door seal/fixing brackets aren’t preventing the door from closing properly. You should also check that there isn’t anything behind the appliance – plug socket/pipes/cables etc – pushing on the rear wall. This can push the top basket fwd , putting pressure on the door and causing sensor/magnet misalignment. One way to check is to bring the machine forward and run a cycle with the machine out of its install . If all that is ok , I’d be looking at a new door lock. Have only ever changed one sensor but that brings up an error code.
Re: Siemens SMV65M00GB/14
Which side tank , left or right ? Not sure it actually fills on the initial start up or during cycles ready for the next fill ? The left hand side tank is the main tank with the right hand side tank only filling at final rinse I think.
