Forum Replies Created
-
AuthorPosts
-
robbo1973
ParticipantRe: apm68855
aw services are your best bet aint got there number on me at mo but i am sure someone will post it.
robbo1973
ParticipantRe: apm68855
vap prob iced up generally the def sensor or cut outs.
robbo1973
ParticipantRe: hotpoint ff187ep strange fault
cheers for reply bob but when i originally cleared the ice i did not switch appliance off i unplugged the fan motor cleared ice and reassembled.also the interior light at the exact same time is still off and when i went today we switched both stat knobs to off position and the green light stayed on is that normal we then turned to i-care and the interior light is still off.
cheers chrisrobbo1973
ParticipantRe: hotpoint ctd40g
thats what i done and now i have the faut coming up re faulty ntc.
robbo1973
ParticipantRe: hotpoint ctd40g
thanks for the replies and the manual will have a peruse.my spares company who are hotpoint agents said there where 2 kits on this model and ser no and i have the correct one with 3 stats.nightmare
robbo1973
ParticipantRe: bounce chqs
hi lee what is this 14 day notice to prosecute you spoke about in the thread is it just a letter or do you use something formal as i have a bounce chq at the mo?
cheers chris
robbo1973
ParticipantRe: Samsung RS21NCSV
i aint got them on me at the mo they are in the office but if the fault was not there then it is then i would assume so.the heater unplugged would defo be picked up.you have to order a full fridge evap as well to un peel the heater for these ridiculous.
robbo1973
ParticipantRe: Samsung RS21NCSV
that is a fault code and if you leave heater disconnected it would not work anyway as when it goes onto defrost it relies on the heater to kick it back in if there is no heat it will stay off for ages and totally defrost.
robbo1973
ParticipantRe: Servis M6852 start button
the start on servis was terrible the best way to start them i found was to strip the handle and put a bit more tension on the little spring then advise the cust to press start BEFORE they close the door if it is the model with the little pcb up top it remembers you have pressed it,then close door firmly and wait it will start.However if she has damaged the buttons etc it may need a new top pcb and if it is janus you wont be able to prog it.
cheers chris
robbo1973
ParticipantRe: Samsung SRS2028CVW
the fan runs when the door is closed so if you tested it with the door switch open it would have no supply.
robbo1973
Participantrobbo1973
ParticipantRe: w/pool arc6680
nobody even got a manual or an idea of fault codes?
cheers chris
robbo1973
ParticipantRe: HJA fridge freezer 6855
if its a beko the def timer is down beside the comp,i did a fridgidaire recently and you had to take the lid off the appliance and it was under there in a recess.
good hunting
robbo1973
ParticipantRe: BEKO WM520S
are these prone to pcb faults?
cheers chrisrobbo1973
ParticipantRe: Samsung RS20CCMS
generally the def sensor yellow wire.meter both heaters and therm fuse if all ok change def sensor.
chris
-
AuthorPosts
