Forum Replies Created
-
Posts
-
Re: Miele 595sc element replacement
Parts very expensive, not too difficult to repair though.
Nettoparts out of stock. £95
Re: Belling Hob rings out of control!!
Its a 444445548, likely needing regulators replacing.
But there are 2 types available
part num’ 082045800 REGULATOR energy 30ER22MHT
part num’ 082590800 REGULATOR energy MP V01SVFor spares try Belling 💡 0871 222 2506
Re: Miele T224 Tumble Dryer
Think its available at about €17.
There are some German sites offering them, you’ll have to translate website to English though.Heres a useful shop on Fleabay that does just that..
Re: zanussi ZWF10070W1 not programming
Or faulty analogical pressure sensor, they are giving a load of problems too.
Re: Zanussi Fault code EC2
Don’t see anything for EC2 listed
EC1 is a flowmeter/valve problem.
EC3 is a weight sensor problemRe: Meile Novotronic W980 Washing Machine check inlet light
Is Water Inlet lit or are Water Inlet & Water Drain lit together?
If Water Inlet is lit it means water level is not reached or reached too slowly.
Re: Miele G685 SC – 3 horizontal lines???
Can be any of 4 faults, F1-F2-F3-F4 each to do with heating cycle, needing a Miele Engineer or one competant to check in service mode which fault it is & to rectify.
Appliance will run only cold wash programs until fault is repaired.Re: Door boot springs
I put washing up liquid on the fingers of both hands.
I start at the bottom putting 3 fingers of each hand on inside of spring leaving thumbs & index fingers to work the spring on as I move both hands around the door gasket, works first time for me every time on any of those machines with inner springs, A.E.G, Zan’, Beko etcRe: belling oven xou117 is my customer deluded?
Have had this a few times with appliances that use selector switch and thermostat mounted on the back, if thermostat is dislodged with its shaft coming out of the the back of selector switch.
Can happen if customer turns selector switch wrong way.
Re: new world dishwasher fault codes.
Drying led flashes Water inlet time too long
Rinse led flashes Drain time too long
Rinse & drain led flashes Heating time too long
Wash led flashes Overfilled
Wash & rinse led flashes Temp’ sensor short circuit
Wash & rinse & drying led flashes Temp sensor open circuitRe: How does the latest safety valve work?
Martin wrote:So it’s just a double solenoid wired in parallel then. 🙂
In the Miele waterproof version that i’ve seen most of in my work there are two separate solenoids wired in parallel but the pipework is obviously in series, this coupled by double walled hose & a float switch which brings on drain pump. They waterproof system will only work when machine is switched on the door closed though.
