Forum Replies Created
-
Posts
-
Re: Looking for a quality machine, problems with Miele/ISE :
Have you contacted Miele Ireland, they cover the island of Ireland.
Re: AEG Arctis 310 gs (old) – orange light remains on
Try turning up t’stat above 1, is it cooling o.k & turning off the compressor or running continuously. Sounds like theres a fault on the fast freeze switch.
Re: BEKO WME7267W FAULT
Could be fault in heater or N.T.C, power off obviously if you are doing any testing.
Re: Miele T294C Condenser dryer TOC
Value is normally printed on the side of T.O.C if you still have it, it may be 175c 😉
check current rating is same though if you don’t use genuine
Re: STOVES Richmond 100G range cooker Model 4444445373.
2 Ignition Gemerators listed, 082825103 & 082598000, fan control p.c.b is part num’ 082814400..
As Kwatt posted, its best to get a repair guy out, flashes from a P.C.B & a Gas cooker are the recipe for a disaster.
Re: Beko DRCS68W condenser dry belt + modif info going on Mo
Beko recommend you change the bearing housing assembly also, new front felts on bearing housings are stitched together & dont fall apart. Clean off the front of the drum of any sticky plastic residue as its this that normally causes the re-occurrance of belts breaking, if its not cleaned it will stick to new felt & take it off .
Re: Zanussi ZCE7700X Cooker
Unlikely to be a fault with the hotplate as it shouldn’t have a supply to it when its not switched on, more likely incorrectly wired or faulty regulator. Multimeter should tell you if theres a supply to it & where its coming from. Check wiring to hob hot switch wasn’t put on wrong place.
Re: Electrolux ESI 6105 Dishwasher-
Normally it requires a controller, power while doing any checks!
Re: Miele W487WPS W/M problem
Water in base most likely the culprit, can also be gunged up pressure vessel.
Re: 3 flashing lights on Beko DE2542F dishwasher – meaning ?
Its 3 months old you say, contact them to repair it under warranty then.
Re: AEG L16820 facia lights flickering
Most likely the loom to lock & p.c.b has burn’t connections. Worst case scenario p.c.b may need replaced.
Advise customer to switch off appliance when not in use to prevent cooking the door lock.Re: Belling part no. required
Is it this one ?
