Forum Replies Created
-
Posts
-
Re: SMEG SE335SS – Element gone
Access may be from the rear. Remove the power supply to the oven first before attempting anything :zap:
Regards
Simon.Re: Hotpoint WF430P Aquarius constantly filling…
If it doesnt fill when it is off then power is being applied to the solenoid valve to let the water in for some reason. This could be board/pressure system fault/wiring etc.
To Hotpoint for a repair!Regards
Simon.Re: Zanussi DE6965 tripping the power !
Unfortunately the only way to surely diagnose the fault would be with someone who had a 500V insulation tester. Check out repairs@ for an engineer in your area. Unplug form mains if you are having a look yourself :zap:
Regards
SimonRe: hotpoint tumble dryer design fault
Have had Indesit IS60V with motor melted belt still under warranty. Cust son had taken it apart. Perhaps the same had happened to this?
S.
Re: Creda T322VW can i retrofit with belt and pulleys?
The slits are there for pulleys. Will need spring too. Thanks Dave will give it a go.
S.
Re: Zanussi WJS1397W prod. 914639503/00
Those sole motors. What an earner. Great when you say to the customer the motor is faulty…… But it can be repaired for a small fee.
S.
Re: Zanussi FLE 1216 w problem
If the water is drained and the power removed does the door still not open?
S.
Re: Safety Issue on Hotpoint Dishwashers
Yep, IDL530 at my local comet with no insulation or plates fitted,
S.
Re: Hotpoint BFI62 fault
If your serial number label has bit 100 on/in (side of door)it it would suggest a problem with the water inlet system. This could be one of many things. You can hear that the water is coming in. I suggest Repairs@ for an engineer to diagnose this one. Unplug power if you are going to have a look yourself :zap:
Regards
SimonRe: Bosch WFF2001GB/01 Heavy duty doorseal
No i was wrong. BSH 296140 £33.14 delivered. 10 -14 days.
S.
Re: Bosch WFF2001GB/01 Heavy duty doorseal
Yes i think it was pattern versus genuine he was probably fobbed off with.
S.
Re: Hotpoint Slimline 7801 not emptying
When you start the program can you hear the drain pump running before the first fill? or just a hum?
Regards
SimonRe: Proline PL105DB Freezer
The compressor is faulty. It may be seized/open circuit winding (not cheap) or the relay may be faulty. If you wish it to be diagnosed check out Repairs@ for an engineer.
Regards
