Forum Replies Created
-
Posts
-
Re: AEG oven switches off
Hi.
Probably not. Usually this can be one of three things in my experience.
1). Main on/off switch contacts failing which means replacing the whole control panel. pt no: 311 38 48-62 / 0.
2). One of the electronics are acting up. Relay board: 899661 37 43-10 / 4 or power board 311 50 05-00 / 5
3). The main oven thermal cut out rated at 180 oC is operating too early. 311 51 90-05 / 4.
1 & 2 are pricey, 3 is not. Which one it is would be impossible to say really as the electronics are only really able to be tested is by means of substitution & really the same goes for the switch.
I assume that the top oven & grill functions are ok. If not then that opens up some further possibilites such as the cooling fan & the like.
Re: How do I code a non-configured PCB – Zanussi WJS1265W
Hi.
The procedure is exactly the same as Martin has outlined.
Re: zanussi zk5648
Hi.
How are the temperatures in either compartment? Let me know.
My first thoughts are either a system fault or in some cases the thermostat phial clamp comes away & as this is foamed in is irrepaiable in the field.
Re: beko fan oven. no model number
Hi.
There is always the slight possibility that the client has a very twitchy RCD.
Re: Zanussi FLS1383 doesn’t spin,
Hi.
You might want to check that the motor tachometer is not loose. This is on the opposite side to the motor shaft & has 2 thin wires going to it.
Re: Electrolux EWN 14780S Error code =(
Hi.
Penguin is right. Error codes begin with E, not C.
If it is E11, this is a water filling problem.
Re: AEG 72630 – Cycle stops after filling
Hi.
There will be a fault code in the memory of E52 usually in the case of worn brushes but this is not usually a code displayed to the user.
Re: Zanisi TD523 loud & rumbly!
Hi.
My money would be that the fan that is bolted onto the motor shaft has worn out.
Re: Beko DW600 cut out
Hi.
There are no fuses aside from the one in the plug. Have you tried pluging it into an alternative socket?
Re: AEG Lavatherm 57700 – Empty Water light
Hi.
I would think that the condensation pump should certainly be replaced. I have had numerous issues with them myself.
Re: New Electrolux Washer (Chinese)
I had a course on these about 2-3 months ago.
Diagnostics & fault codes totally different to anything Lux have pushed out.
Re: Zanussi FLS1383 doesn’t spin,
The air chamber is next to check. It is where the black rubber hose from the pressure switch goes to. They get all gunged up & can cause all sorts of issues.
