Forum Replies Created
-
Posts
-
Re: DIPLOMAT TIMER
sure about it being the timer? do a lot of those and that is a rare failure indeed.
Re: same amount
Charge your normal fee for both, they will of course be expecting a warranty on all your work after all.
Re: MFI
AIG been a problem since day 1 we had to direct invoice them. Rejected claims that they didnt bother to tell us about, ignored statements etc and adjusted invoices by 1p to account for their lack of being able to round up vat. 1 outstanding invoice form April as yet unpaid, been on stop since June but must admit no AIG calls have even been passed to us since then which leads me to believe they have fallen out with MFI and there will be no further business with them.
Re: Kitchons.com
Notice Martin has cottoned on to this:
http://www.ukwhitegoods.co.uk/modules.p … 0&postdaysNo doubt another screen id will be created now.
Re: bc82gl baumatic hood
Did a BT 82Gi the other day, there were screws either side of the switch box that could not be seen, a longish phillips driver reached them and then the whole swtich pulled inside and out.
Re: Smeg DWI 410 Pulsing Drain Pump
classic dispenser symptoms, slave on any old solonoid valve to prove it. Could have done the boards as well.
Re: smeg d/washer dwd1sse,no go?
should show a fault code, but the clunking noise could either be a blocked drain pump (as that is powered up straight away) or the alternating valve maybe (usually gives a fault code though).
Re: Delivery drivers.
I have had a report that a recent delivery appeared to be dropped of by what looked like a couple of gypsies in an old transit van.
Re: Electrolux EWD1409i washer drier.
Yes, changed the main board and interlock (as a precaution) but on doing so the display board failed to light up so it needed on of those as well, we think its caused by customers leaving the machine turned on 24/7.
Re: SMEG SE210X oven. Fan fault
Sure nobody’s had a go already and got a wire wrong? Pretty basic oven, guess it can only be the comm switch. Have you checked for a burnt out terminal block or door switch?
check your e mail.Re: MFI
This end the work volume has got higher, payments are coming faster (with the exception, needless to say of AIG) and the product has got better (mainly see Beko dishwashers in new instalations rather than the Hairer stuff) and not had a rejection in a year or so. Not much to complain about here….for now.
Re: ASKO bearing change W6461
Find it hard to believe they would have gone on a 6461….. Its a methodical strip down from the front. Nothing tricky but not like any other machine you would have worked on. IMO the centralising tool is not vital, the bearing insertion tool is though.
Re: Asko d1876 dishwasher error codes ?
Sorry, have had a look at my technical stuff here but can see nothing on error codes for that model.
