Forum Replies Created
-
Posts
-
thats almost like saying they know your machines gonna break down
save your money and buy something proper next time
my drugs still havent worn off, by the way
why should there be, theyre self diagnostic!
and it tells you every known fault via display, so why use a pc, when the machine will tell you itself?
unplug it
defrost it fully, for 48hrs, with both doors open
plug it back in
thats it!!!
its clogged up with ice and the fan no longer runs, thats all
you could fit a pcb if you like, but youll find the defrost will cure it
hope this helps
test the heater with a meter
if thats ok, its the control pcb
if your confident at board level, you may well find a bad solder joint on the heater relay on the board
do you mean the felt seal?
i just scrape it all off, and clean it with white spirit!
theres a full kit for that, part number 1703080
inexpensive… includes front and back seal, bearing supports, shaft, rear bearing and drive pin
Re: Ariston AV1048C, drum not turning
evan wrote:Connector looked fine, no corrosion or anything. I put it back together and it came back to life 😯
I wonder if just switching it off and on at the mains would have done the same trick.Anyway, going to treat it to a new set of brushes before I put it back to work.
Thanks!
like i said, and theres your answer, the connections on the pcb on that model sometimes arc and break connection, an easy repair if you know what your doing
its not the motor plug, its the copper track where it fits on the board where the problem lies!! look again and youll see what i meanare you sure the connection for the motor plug on the control board isnt damaged?
id be checkin that in the first instance!!
best of luck
problem with the plastic, and you not unique, they press the cabinet together with the plastic on, so the plastic sricks between the joints!!
if your very carefull, and heat it up, using a very blunt knife or similar,and score down the line, gently, and it will come out
be careful not to scratch it, thats all
like i said, ur not unique, most people leave it on, but it does look a hell of a lot better without
