Forum Replies Created
-
Posts
-
Re: Servis M6135
On all SUK machines with this type of selector always put dial to stop before reprogramming and wait for the start button to flash.Tell customer to do this every time even if the same prog is required. These can remember parts of previous programmes, ie they spin only, continuously fill or wash forever. This will clear the memory. Had three like this this week. Nice little earner.
RobRe: Bosch tumble…WTA3204GB/09
Thanks Martin,
No other replies and I think you are probably right so will advise customer. Here goes :rolls:
RobRe: Guess how she does it ? Contains tame female nudity …
Dunno about anyone else but that tune just goes around and around my head, and she was ok too
RobRe: What happened to Quality?
Who in their right minds puts 6kg in each load…no one. they put around 5lb so that one goes up in smoke.
But that’s still no excuse for the machine to last less than three years.My Hitachi (old Servis quartz to the uninitiated) is 17 years old and never broke down.
RobRe: Servis S 900 wd misbehaviour
Hi AT,
Rust spots could be due to the bearing seal starting to fail. ie rusty water from the bearings in with the wash. Is the machine getting noisy on spin?
RobRe: White Knight CL847 sensordryer
god,
you’re going back a bit…Carter motors brilliant
Rob 😆 😆 😉Re: INSURANCE WORK
end of month following the month of the job so 28-62 days depending on the date of job.
They do pay on time but still not enough.
RobRe: Bosch D/W
Hi Martin,
The heater reaches temp ok.
You can cancel the prog but to reset another prog you have to switch off . Hope that clarifies it.
Where is the Turbidity sensor and what does it do? and surely this waoul cause probs on all programmes
Thanks
Rob
PS Never worked on one of these before, always avoided them
