Forum Replies Created
-
Posts
-
Re: Miele dishwasher G646 fan problem.
As far as i’m aware on Miele D’Washers there were a few times for fan run-on, in programming mode it could be set for 4 mins, 14 mins or 45 mins.
It is changeable.Re: AEG D/W (Pnc 911 232 407 01)
899646 13 37-30 / 6 capacitor
899646 14 44-49 / 0 anti interference filterRe: AEG B4101-4-M oven – Cooling Fan does not cut out
Is it the fan at back of oven or fan on top of oven that continues to run? Cooling fan (on top) should stop after temp’ is acheived. It may not be cutting out because of a faulty temperature switch. PNC number needed to identify specific part required.
Power off when testing 💡
Re: AEG lavamat 76810 motor not working
The machine may have a 3 phase motor. An electronic inverter circuit board controls all motor actions on these type of machine. It stores dangerous voltages even when the supply is off so not to be repaired or serviced by any who isn’t competant to do so.
Re: AEG DEAD APART FROM AN E CODE
E30s are all related to pressure switch (water level).
Machine may not have emptied all the water out for instance.Re: Miele D/W G1220SC error F014
could be something blocking the impellor of the pump, the circulation pump is easilly dismantled, i’ve had paper/plastic etc caught up in them causing the said problem
Re: Miele T230c
What is the problem you are having with the appliance, perhaps if you post the problem someone can help you.
Re: AEG 808601 (PNC9112347201-01)
C3 means the pump is on for more that 15 sec’s without being asked to be on by the electronic. So it could be a float switch problem or PCB fault.
Re: miele t650c
Machine senses (in auto programme) that there are no damp clothes in drum so doesn’t switch on heater. Try using “Timed drying” programme which should heat for selected time. The machine measures resistance between drum paddles & drum to detect moisture or the lack of it. If you take off the lid you will see a carbon brush running on a slip-ring around the drum outer that measures the resistance of the circuit.
Re: Miele not draining with a full load
Manifold at the back acts as an air-break to prevent syphoning, it sometimes can get blocked with fluff off bathroom mats or throws etc and cause the problem described. It can be taken off & cleaned by flushing water through it. If you need to clean it out, make sure power is off & remove top, front & side panel. Now you can get access to all the drainage components easily.
Re: Miele G646SC dishwasher
Is circulation motor turning by hand?
You should be able to turn the shaft at motor end with fingers or pliers.
Power off obviously!
Circ’ pump could be jammed, which is a common problem, if no pressure is shown by pressure sw’ after supply is applied to motor it shows fault, its quite easy to disassemble the circulation pump to check for foreign bodies fouling impellor.Re: zanussi 12170w..s.no. 74600150..pn..91426105(00)
I’ll e-mail you in more detail, but its likely that machine has’nt emptied all the water from previous wash. Pull out machine, tip back, open filter check for blockage and that impeller is free, failing this check sump hose, drain hose etc. On start up machine runs to get rid of any water, it won’t fill if water is shown still in machine.
