Forum Replies Created
-
AuthorPosts
-
electrofix
ModeratorRe: Smeg DF614SF dishwasher
first thing I would check is the button operation
ie has the board moved or a plastic part snapped that stops the switch being depressed
Dave
electrofix
ModeratorRe: Leisure Roma Second Oven not working
its one of those question “how long is a piece of string but it prob boils down to thermostats or switches as if the elements had failed the light would still light
also if this unit has a clock then it might be thatpost the full model to enable someone to look up the info on it
Dave
November 14, 2014 at 11:19 pm in reply to: Whirpool 6Th Sense – Short Program Takes Hours To Complete #421505electrofix
ModeratorRe: Whirpool 6Th Sense – Short Program Takes Hours To Comple
various things can extend a programme but on most modern machines they come up with a fault code
no sure with the whirlpool off hand but I would check
1 time to fill since the machine fills about 4 times if it takes too long it adds time times 4
2 drain same reason
3 heater some machine like bosch and zanussi don’t give a fault code for failed heater just makes the programme longer while it waits for heat and then give up and finishes programmecheck the programme you are using against the handbook time to see how far out it is
Dave
electrofix
ModeratorRe: Bosch WAA28161GB/09 surging motor
if you spin the motor and set your meter on low ac volts you should see an output. if no output check for broken magnet
is it a controlled surge ie does it speed you quickly or instantly
if instantly suspect also the motor triac
measure motor from board to rule out broken wires duff connectors etc
Dave
November 13, 2014 at 2:03 pm in reply to: Bosch Exxcel SGS45E02GB – Water overflowing base on startup #421279electrofix
ModeratorRe: Bosch Exxcel SGS45E02GB – Water overflowing base on star
you fault sounds like a timer fault ie the component that controls the valve is faulty
the fault with the timer was a bad joint on the heater circuit that goes pop and can blow other components when it failsthey cant repair the timer so you will get a new one
get them out to it and see how you go from there
Dave
electrofix
ModeratorRe: Whirlpool adp 8693 dishwasher
broken wires, relay on board inc blown track and solder joints, safety stats if fitted
Dave
electrofix
ModeratorRe: Those little Beko dryer belts on the motor
I can send you the info but need model so i am sending the right files. but the one i looked at was a how to take apart and did not show how they recomend putting this belt back on
Dave
electrofix
ModeratorRe: Dimplex LXY15 Loxley Optiflame electric fire.
had one similar the other week board duff
shorted out main relay. found the thermostat part of the board still worked so customer very happy to use manually
Dave
electrofix
ModeratorRe: Lamona Dishwasher HAJ8631
hi geoff1
if you pm taff you can add files
do it all the timeDave
electrofix
ModeratorRe: Whirlpool adp 8693 dishwasher
what resistance of the heater? if its under 100 ohms disconnected then its ok
Dave
electrofix
ModeratorRe: bosch dryer
take it you have checked door switch
Dave
electrofix
ModeratorRe: Neff B1476 temp light flashing but no heat
take it out, turn it over and look for blown tracks
Dave
electrofix
ModeratorRe: Hoover tumble dryer relay PCB
small capacitor white tube from memory think its .22uF
Dave
electrofix
ModeratorRe: Diplomat dishwasher APD 8902
that does not sound good. they dont operate valves with relays
Dave
electrofix
ModeratorRe: Neff B1476 temp light flashing but no heat
if the element went with a bang it may have damaged the control boards
Dave
-
AuthorPosts
