[PINKY]

Re: zanussi zwf14280w

Have an ‘e43’ error code. triac fault although pcb looks ok. Is this common on these? is it a case of a new pcb?
pnc 914522518
Pinky

[PINKY]

Re: Bosch D/W SGS43E02GB/43

Water points motor blowing a triac? Look again at the pcb, Not unheard of

[PINKY]

Re: employment

:rolls:

[PINKY]

Re: bosch d/w sgv43a03gb/38

Blown triac on main pcb will do this. Usually caused by faulty water points motor [part of the heater] or dispenser solenoid

[PINKY]

Re: BOSCH EXEL DISHWASHER SMS63E09GB/02

‘e25’ blocked drain pump!! Make sure you take the pump right out to check it. Sometimes a pump itself will throw up this error although it will work other times it can be a resistance reading on the wash motor tricking the pcb. Self Diagnostics! Don’t we luv em!!!!!

[PINKY]

Re: bosch SMS50E06 GB07

R/h panel off, Door skin off, plinth off. Cut off hose clip type thingy. Pull out heat pump 😀 Easy peasy. 40mins on a go slow, 15min when you have done a few 😉

[PINKY]

Re: Bosch WF0285SGB One minute

Unlikely tbh. Jammed filter probably bra wire or similar. ‘1min’ usually means timed out in heating

[PINKY]

Re: Neff Dishwasher S54m45x5gb/01

Triac blown on main pcb?

[PINKY]

Re: Neff S54T09X1GB/06 Integ D/W

Water points def favorite for this sort of fault

[PINKY]

Re: Bosch WVT 1260

There is no mod on the dispenser hose. 😥

[PINKY]

Re: Bosch Chip Blown on Board

Motor or heating element most common cause

[PINKY]

Re: Bosch WFF2000

Blocked pressure chamber was a favourite on these and while your cleaning that its wise to check the heater, Clear the anti syphon box and check valve coils. Usually covers all bases assuming it passes the Mega test 😉

[PINKY]

Re: bosch dryer fitting belt

It’s a pig but easier from the back 😉

[PINKY]

Re: Bosch SGS 55C02GB/01

Water point motor in the heater. changes from top to bottom spray arms? Assuming its no older than about 6yrs? Would need a new heater unless there is some thing jamming it

Pinky

[PINKY]

Re: bosch kgv3640gb/07

No such model?

If it’s a wet wall fridge with no divertor valve and a normal evaporator style freezer i’d say it has a system fault, Low on gas, Weak compressor or system blockage.

What’s the FD? or approx age. Going to be one for the skip me thinks

[Author]

Posts