Forum Replies Created
-
Posts
-
Re: Miele W916 – No 20/32717903
Does it also say “Check Inlet”?
Sounds like it could be a water inlet problem! 😉
I’d check water inlet hose, valves, filter in inlet.
Also look if theres been a leak & activated float switch if one is fitted in machine base.Re: miele w844
Likely motor brushes worn away?
Did you take end off motor & check them?
This can be done without removing the motor.
I’ve come across faulty boards but i’d check brushes & cable loom motor plug first
Part num’ – brushes:- 4297411Re: AEG 61300 tumbles 1 way all the time
Timer assy laundry 914001129 £340
😯 thats why i need to be sure!
Re: Miele G7859 dishwasher F A fault
F.A Normally means a drain probem on Miele Commercial machines i’ve seen. Look for kinked or blocked drain hose or pump problem (blockage in non return valve) 💡 .
Re: Miele Dishwasher G686SC
Roly he shouldn’t have to open it up!
Most Miele engineers should be competant enough to enter service mode & see fault codes which should help in pinpointing cause of failure.
One of these would say “float switch activated” if theres water in base, if you get my jist.Re: Miele Dishwasher G686SC
Could be as simple as inlet filter on water pipe blocked, or flow meter problem.
Most likely the level switch not getting enough pressure of water, this can because machine did not fill with enough water to bring on pressure switch or that there is an obstruction in the circulation pump.Re: Glasswasher
Could be a thermal overload somewhere on bottom of tank, this goes out sometimes if machine is drained of water & boils dry.
Normally has red reset button.
Also check if theres a relay suplying the heater, could be a bad connection there.
Re: This May Be A Long Shot But Search Your Shelves
Prices a bit stiff on that website i thought but perhaps its discounted for trade?
Re: miele g679sc program lights flashing
Well its not a water fill problem. Do you know how to get into service mode?
Re: miele g679sc program lights flashing
Have you fitted a new Reed Switch or just taken old one out & put it back?
I’ve found its sometimes difficult to get then seated correctly for the magnet to move the switch.
Also check you haven’t pulled the cable off the Electronic board.
If Electronic doesn’t receive any pulse from reed sw’ it usually gives an Inlet Fault.
Is this what you get?Re: Miele W 3740-just delivered
Teresa, the hook end clips off the outlet hose-pipe, have you noticed this?
It can be joined directly to another pipe without the hook piece.Re: MIELE T430 no motor action
Sent you a PM Trotter, best of luck in sourcing relay as board is £160ish
