Forum Replies Created
-
Posts
-
Re: F&P IW712E Fault 37
Yep Fault Code 37
Reads while draining .the water level from pressure sensor has not changed over 3 Mins
Check for pump blockages Prseeure Tube Etc Not Kinked (As You Have)
Pressure Swicth Is Integrated into Main Motor Controller (PCB)
I have unfortunately Replaced for this fault beforeRe: fisher and paykel 703 error code 9?
Forgetting the fault code
Symptoms suggest Faulty Lid Switch(reed switch)Re: F&P Smartdrive MW059 – 00111110 error code
Fault Code 62
Indicates Excessive Pump Curren
Usually faulty pump (Pump Trips out When it overheats)
In Some instances Thou it may be Motor ControllerRe: Fisher & Paykel 703 Smart Drive wont drain or comple
IF you have Just Washed Woolen underlay
Pump Probably Blocked up with underlay fibresRe: F&P Fresh 5.0 Smartdrive 9
Probably Phase 5 Washer IE MODEL MW059 Or GW509 ??
Power off at Console
Press & Hold Temp Up Then POWER Button
Should get 4 Short Beeps
Press Up Temp Botton TIL Cold LED ON For 5-5.5KG Washer
Press Power Button to exit Mode & storeRegards
Note Model # Is At the Rear/Top Of WasherRe: F & P 501 smartdrive Filling slowly????
Inlet valve will have to be replaced
Part # 426143 About $45 Aud
The valve itself fails not so much the coilRe: F&P GW711 error code 56
Rotor postion sensor located with motor underneath washer bowl
Your problem can however be related to Motor controller(Main PCB)
Re: MW511 (Pride) washer wont fill with water
Fault code 39 indicates a pressure switch /tube failure
Check pressure tube is not blocked ,kinked ,dislodged
Secondary cause suggests pressure sensor failure which unfortunately is integrated into the main Motor controller /PCBRe: whirlpool ADP 5550 DW
If Flashing 6 times pausing then flashing 6X
Water inlet fault
Check the simple things first IE water supply(is tap turned on),blocked inlet hose filter.Inlet hose kinked
Or could be possible water inlet valve fault ,defective flow meterRe: speed sensors
It is indeed made by LG
SE Error As Penguin Suggested Check wiring harness & connectors to motor & PCB Otherwise could be motor
If youhave to go for motor get it from LG About $50.00Au
Motor from West /Electrolux $170.00AudRe: Westinghouse Silhouette fridge/freezer
Full Model Number would be helpful
Found down near the crispersRe: broken f&p mw511!!!!!
Fault code 34 does relate to a faulty motor controller(Main PCB)
YEP Not much change out of $300.00
